GitLab

Convert them to take an mpidr instead of a (cluster, core) pair. This
simplifies all of the call sites, and actually makes the functions a bit
smaller.
Signed-off-by: Samuel Holland <samuel@sholland.org>

This maximizes the amount of data protected by the MMU.
Signed-off-by: Samuel Holland <samuel@sholland.org>

A DDR calibration value is missing write mask, causing ECC DDR calibration
to fail. This patch addresses the issue. ECC should also be scrubbed before
MMU initializes, thus the scrubbing is moved to ddr intialization phase.
Signed-off-by: Loh Tien Hock <tien.hock.loh@intel.com>

This commit migrates to MULTI_CONSOLE_API for IMX Warp7 board.
We also rename the functions in imx_uart driver to more specific one.
Signed-off-by: Ying-Chun Liu (PaulLiu) <paulliu@debian.org>

ATF should be the only host needing to control a processor that it has
started. ATF will need this control to stop the core later. Do not
relinquish control of a core after starting the core.
Signed-off-by: Andrew F. Davis <afd@ti.com>

Now that we have non-blocking TI-SCI functions we can initiate the shutdown
sequence from the PSCI handler without needing the ti_sci_proc_shutdown
helper function, which is removed. This gives us the greater control and
flexibility that will be needed when cluster power down sequences are added.
Signed-off-by: Andrew F. Davis <afd@ti.com>

Most TI-SCI functions request an ACK and wait until it is received. For
some power sequence tasks we cannot wait but instead queue messages
asynchronously. Three messages have been identified that will need to
be used in this way. Add non-waiting versions of these functions.
Signed-off-by: Andrew F. Davis <afd@ti.com>

Currently almost all TI-SCI messages request and check for an ACK from
the system firmware. Move this into a common place to remove the same
from each function.
Signed-off-by: Andrew F. Davis <afd@ti.com>

When a device is requested with TI-SCI its control can be made exclusive
to the requesting host. This was currently the default but is not what
is needed most of the time. Add _exclusive versions of the request
functions and remove the exclusive flag from the default version.
Signed-off-by: Andrew F. Davis <afd@ti.com>

The raw get and set state functions for both devices and clocks
are only meant for use internal to the TI-SCI driver, the same
functionality is available from the other API that call into
these. Remove them from the external interface and make them
static scope to the driver.
Signed-off-by: Andrew F. Davis <afd@ti.com>

There exists a third DMA controller on the hi3660
SoC called the IOMCU DMAC. This controller is used by
peripherals like SPI2 and UART3. Initialize channels 4-7
as non-secure, while 0-3 remain reserved and secure.
Signed-off-by: Ryan Grachek <ryan@edited.us>

This patch introduces explicit linker variables to mark the start and
end of the per-cpu bakery lock section to help bakery_lock_normal.c
calculate the size of the section. This patch removes the previously
used '__PERCPU_BAKERY_LOCK_SIZE__' linker variable to make the code
uniform across GNU linker and ARM linker.

Change-Id: Ie0c51702cbc0fe8a2076005344a1fcebb48e7cca
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch includes bl_common.h from plat_trampoline.S to link with
the __BL31_END__ symbol.

Change-Id: Ie66c5009018472607db668583c9a0b3553f0ae73
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch modfies the 'tegra_soc_pwr_domain_power_down_wfi' handler
to use BL31_BASE variable, provided by bl_common.h

Change-Id: I9747228d0193c1ae6999284458b9f866955a61a2
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch removes the unused functions that are marked as .global
in code but not defined anywhere in the code.

Change-Id: Ia5057a77c0b0b4a61043eab868734cd3437304cc
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch stops including common_def.h from platform_def.h to
fix a circular depoendency between them.

This means platform_def.h now has to define the linker macros:
* PLATFORM_LINKER_FORMAT
* PLATFORM_LINKER_ARCH

Change-Id: Icd540b1bd32fb37e0e455e9146c8b7f4b314e012
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

The scatterfile to support armlink, does not seem to support
shift operator. To handle this define CACHE_WRITEBACK_GRANULE with
the direct value.

Change-Id: I19afc7cb9c55a08cb0703f284d91018d3214353f
Signed-off-by: Kalyani Chidambaram <kalyanic@nvidia.com>

This patch removes this macro and its usage as it is used only
within the Tegra186 files and all derived platforms keep the
macro enabled.

Change-Id: Ib831b3c002ba4dedc3d5fafbb7d321daa28fa9ea
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch dynamically maps the first page of trusty's code memory,
before accessing it to find out if we are running a 32-bit or 64-bit
image.

On Tegra platforms, this means we have to increase the mappings to
accomodate the new memmap entry.

Change-Id: If370d1e6cfcccd69b260134c1b462d8d17bee03d
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch initilises the per-CPU GIC bits during cold boot and
secondary CPU power up. Commit 80c50eea

 accidentally left out this
part.

Change-Id: I73ce59dbc83580a84b827cab89fe7e1f65f9f130
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch udpates the SPE console driver to prepend '\r' to
'\n'. This fixes the alignment of prints seen by the host
machines on their UART ports.

Tested by collecting the logs from host PC using Cutecom

Reported by: Mustafa Bilgen <mbilgen@nvidia.com>

Change-Id: I6e0b412bd71ff5eb889582071df8c157da5175ed
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

As per ARM ARM D1.17.2, any physical IRQ interrupt received by the PE
will be treated as a wake-up event, if SCR_EL3.IRQ is set to '1',
irrespective of the value of the PSTATE.I bit value.

This patch programs the SCR_EL3.IRQ bit before entering CPU standby
state, to allow an IRQ to wake the PE. On waking up, the previous
SCR_EL3 value is restored.

Change-Id: Ie81cf3a7668f5ac35f4bf2ecc461b91b9b60650c
Signed-off-by: Vignesh Radhakrishnan <vigneshr@nvidia.com>

This patch redefines the variable LIBC_SRCS for Tegra platforms,
to remove unused libc files from the list. This patch is a building
block to eventually use other libc implementations in the future.

Change-Id: Iccde5a75f5e2d6f4e2dbc6274beb423b80e846fd
Signed-off-by: Anthony Zhou <anzhou@nvidia.com>
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This adds BL2 support for Intel Stratix 10 SoC FPGA.
Functionality includes:
- Release and setup peripherals from reset
- Calibrate DDR
- ECC DDR Scrubbing
- Load FIP (bl31 and bl33)
Signed-off-by: Loh Tien Hock <tien.hock.loh@intel.com>

Also, update platform_def.h guidelines about includes in the porting
guide.

Change-Id: I1ae338c9dd3242b309f6d53687ba2cb755d488c3
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

Many parts of the code were duplicating symbols that are defined in
include/common/bl_common.h. It is better to only use the definitions in
this header.

As all the symbols refer to virtual addresses, they have to be
uintptr_t, not unsigned long. This has also been fixed in bl_common.h.

Change-Id: I204081af78326ced03fb05f69846f229d324c711
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

The BL33 image must not go past the end of DRAM.

Change-Id: I56668ab760d82332d69a8904d125d9a055aa91d5
Signed-off-by: Sandrine Bailleux <sandrine.bailleux@arm.com>

PLAT_ARM_NS_IMAGE_OFFSET is in fact not an offset relative to some base
address, it is an absolute address. Rename it to avoid any confusion.

Change-Id: I1f7f5e8553cb267786afe7e5f3cd4d665b610d3f
Signed-off-by: Sandrine Bailleux <sandrine.bailleux@arm.com>

This patch inits SDHost in BL2 earlysetup. BL2 can start operating mmc
commands to read/write MMC raw blocks.
Signed-off-by: Ying-Chun Liu (PaulLiu) <paulliu@debian.org>

Platforms that do not support bpmp firmware, do not need access
to the PMC block from outside of the CPU complex. The agents
running on the CPU can always access the PMC through the EL3
exception space.

This patch restricts non-secure world access to the PMC block on
such platforms.

Change-Id: I2c4318dc07ddf6407c1700595e0f4aac377ba258
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

As per the latest recommendations from the hardware team, write access
needs to be disabled for APE, BPMP, NvDec and SCE clients. This patch
disables stream id register writes for these MC clients to implement
those recommendations.

Change-Id: I8887c0f2cc5bc3fc5bba42074810ba5c1d3f121f
Signed-off-by: Krishna Reddy <vdumpa@nvidia.com>

This patch updates the state machine to "not present" if the bpmp
firmware is not found in the system during boot. The suspend
handler also checks now if the interface exists, before updating
the internal state machine.

Reported by: Kalyani Chidambaram Vaidyanathan <kalyanic@nvidia.com>

Change-Id: If8fd7f8e412bb603944555c24826855226e7f48c
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch toggles the ring oscillator state across cluster idle
as DFLL loses its state. We dont want garbage values being written
to the pmic when we enter cluster idle state, so enable "open loop"
when we enter CC6 and restore the state to "closed loop" on exit.

Change-Id: I56f4649f57bcc651d6c415a6dcdc978e9444c97b
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch clears the PMC's DPD registers on resuming from System
Suspend, for all Tegra210 platforms that support the sc7entry-fw.

Change-Id: I7881ef0a5f609ed28b158bc2f4016abea3c7f305
Signed-off-by: kalyani chidambaram <kalyanic@nvidia.com>

The BPMP firmware takes some time to initialise its state on exiting
System Suspend state. The CPU needs to synchronize with the BPMP during
this process to avoid any race conditions. This patch suspends and resumes
the BPMP interface across a System Suspend cycle, to fix this race.

Change-Id: I82a61d12ef3eee267bdd8d4386bed23397fbfd2d
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch adds suspend and resume handlers for the BPMP
interface. Mark the interface as "suspended" before entering
System Suspend and verify that BPMP is alive on exit.

Change-Id: I74ccbc86125079b46d06360fc4c7e8a5acfbdfb2
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch skips past the signature header added to the sc7entry-fw
binary by the previous level bootloader. Currently, the size of
the header is 1KB, so adjust the start address and the binary size
at the time of copy.

Change-Id: Id0494548009749035846d54df417a960c640c8f9
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch uses the sc7entry-fw base/size values to calculate the
TZDRAM fence, so as to move sc7entry-fw inside the TZDRAM fence.

Change-Id: I91aeeeece857076c478cdc4c18a6ad70dc265031
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>

This patch adds SiP handler for Tegra210 platforms to service
read/write requests for PMC block. None of the secure registers
are accessible to the NS world though.

Change-Id: I7dc1f10c6a6ee6efc642ddcfb1170fb36d3accff
Signed-off-by: kalyani chidambaram <kalyanic@nvidia.com>

This patch puts all the DMA masters in reset before starting the System
Suspend sequence. This helps us make sure that there are no rogue agents
in the system trying to over-write the SC7 Entry Firmware with their own.

Change-Id: I7eb39999d229951e612fbfeb9f86c4efb8f98b5a
Signed-off-by: Varun Wadekar <vwadekar@nvidia.com>