/* * Copyright (C) 2018 Marvell International Ltd. * * SPDX-License-Identifier: BSD-3-Clause * https://spdx.org/licenses */ /* AP807 Marvell SoC driver */ #include #include #include #include #include #include #include #include #define SMMU_sACR (MVEBU_SMMU_BASE + 0x10) #define SMMU_sACR_PG_64K (1 << 16) #define CCU_GSPMU_CR (MVEBU_CCU_BASE(MVEBU_AP0) \ + 0x3F0) #define GSPMU_CPU_CONTROL (0x1 << 0) #define CCU_HTC_CR (MVEBU_CCU_BASE(MVEBU_AP0) \ + 0x200) #define CCU_SET_POC_OFFSET 5 #define DSS_CR0 (MVEBU_RFU_BASE + 0x100) #define DVM_48BIT_VA_ENABLE (1 << 21) /* SoC RFU / IHBx4 Control */ #define MCIX4_807_REG_START_ADDR_REG(unit_id) (MVEBU_RFU_BASE + \ 0x4258 + (unit_id * 0x4)) /* Secure MoChi incoming access */ #define SEC_MOCHI_IN_ACC_REG (MVEBU_RFU_BASE + 0x4738) #define SEC_MOCHI_IN_ACC_IHB0_EN (1) #define SEC_MOCHI_IN_ACC_IHB1_EN (1 << 3) #define SEC_MOCHI_IN_ACC_IHB2_EN (1 << 6) #define SEC_MOCHI_IN_ACC_PIDI_EN (1 << 9) #define SEC_IN_ACCESS_ENA_ALL_MASTERS (SEC_MOCHI_IN_ACC_IHB0_EN | \ SEC_MOCHI_IN_ACC_IHB1_EN | \ SEC_MOCHI_IN_ACC_IHB2_EN | \ SEC_MOCHI_IN_ACC_PIDI_EN) /* SYSRST_OUTn Config definitions */ #define MVEBU_SYSRST_OUT_CONFIG_REG (MVEBU_MISC_SOC_BASE + 0x4) #define WD_MASK_SYS_RST_OUT (1 << 2) /* DSS PHY for DRAM */ #define DSS_SCR_REG (MVEBU_RFU_BASE + 0x208) #define DSS_PPROT_OFFS 4 #define DSS_PPROT_MASK 0x7 #define DSS_PPROT_PRIV_SECURE_DATA 0x1 /* Used for Units of AP-807 (e.g. SDIO and etc) */ #define MVEBU_AXI_ATTR_BASE (MVEBU_REGS_BASE + 0x6F4580) #define MVEBU_AXI_ATTR_REG(index) (MVEBU_AXI_ATTR_BASE + \ 0x4 * index) enum axi_attr { AXI_SDIO_ATTR = 0, AXI_DFX_ATTR, AXI_MAX_ATTR, }; static void ap_sec_masters_access_en(uint32_t enable) { uint32_t reg; /* Open/Close incoming access for all masters. * The access is disabled in trusted boot mode * Could only be done in EL3 */ reg = mmio_read_32(SEC_MOCHI_IN_ACC_REG); if (enable) mmio_write_32(SEC_MOCHI_IN_ACC_REG, reg | SEC_IN_ACCESS_ENA_ALL_MASTERS); else mmio_write_32(SEC_MOCHI_IN_ACC_REG, reg & ~SEC_IN_ACCESS_ENA_ALL_MASTERS); } static void setup_smmu(void) { uint32_t reg; /* Set the SMMU page size to 64 KB */ reg = mmio_read_32(SMMU_sACR); reg |= SMMU_sACR_PG_64K; mmio_write_32(SMMU_sACR, reg); } static void init_aurora2(void) { uint32_t reg; /* Enable GSPMU control by CPU */ reg = mmio_read_32(CCU_GSPMU_CR); reg |= GSPMU_CPU_CONTROL; mmio_write_32(CCU_GSPMU_CR, reg); #if LLC_ENABLE /* Enable LLC for AP807 in exclusive mode */ llc_enable(0, 1); /* Set point of coherency to DDR. * This is required by units which have * SW cache coherency */ reg = mmio_read_32(CCU_HTC_CR); reg |= (0x1 << CCU_SET_POC_OFFSET); mmio_write_32(CCU_HTC_CR, reg); #endif /* LLC_ENABLE */ } /* MCIx indirect access register are based by default at 0xf4000000/0xf6000000 * to avoid conflict of internal registers of units connected via MCIx, which * can be based on the same address (i.e CP1 base is also 0xf4000000), * the following routines remaps the MCIx indirect bases to another domain */ static void mci_remap_indirect_access_base(void) { uint32_t mci; for (mci = 0; mci < MCI_MAX_UNIT_ID; mci++) mmio_write_32(MCIX4_807_REG_START_ADDR_REG(mci), MVEBU_MCI_REG_BASE_REMAP(mci) >> MCI_REMAP_OFF_SHIFT); } static void ap807_axi_attr_init(void) { uint32_t index, data; /* Initialize AXI attributes for AP807 */ /* Go over the AXI attributes and set Ax-Cache and Ax-Domain */ for (index = 0; index < AXI_MAX_ATTR; index++) { switch (index) { /* DFX works with no coherent only - * there's no option to configure the Ax-Cache and Ax-Domain */ case AXI_DFX_ATTR: continue; default: /* Set Ax-Cache as cacheable, no allocate, modifiable, * bufferable. * The values are different because Read & Write * definition is different in Ax-Cache */ data = mmio_read_32(MVEBU_AXI_ATTR_REG(index)); data &= ~MVEBU_AXI_ATTR_ARCACHE_MASK; data |= (CACHE_ATTR_WRITE_ALLOC | CACHE_ATTR_CACHEABLE | CACHE_ATTR_BUFFERABLE) << MVEBU_AXI_ATTR_ARCACHE_OFFSET; data &= ~MVEBU_AXI_ATTR_AWCACHE_MASK; data |= (CACHE_ATTR_READ_ALLOC | CACHE_ATTR_CACHEABLE | CACHE_ATTR_BUFFERABLE) << MVEBU_AXI_ATTR_AWCACHE_OFFSET; /* Set Ax-Domain as Outer domain */ data &= ~MVEBU_AXI_ATTR_ARDOMAIN_MASK; data |= DOMAIN_OUTER_SHAREABLE << MVEBU_AXI_ATTR_ARDOMAIN_OFFSET; data &= ~MVEBU_AXI_ATTR_AWDOMAIN_MASK; data |= DOMAIN_OUTER_SHAREABLE << MVEBU_AXI_ATTR_AWDOMAIN_OFFSET; mmio_write_32(MVEBU_AXI_ATTR_REG(index), data); } } } static void misc_soc_configurations(void) { uint32_t reg; /* Enable 48-bit VA */ mmio_setbits_32(DSS_CR0, DVM_48BIT_VA_ENABLE); /* Un-mask Watchdog reset from influencing the SYSRST_OUTn. * Otherwise, upon WD timeout, the WD reset signal won't trigger reset */ reg = mmio_read_32(MVEBU_SYSRST_OUT_CONFIG_REG); reg &= ~(WD_MASK_SYS_RST_OUT); mmio_write_32(MVEBU_SYSRST_OUT_CONFIG_REG, reg); } void ap_init(void) { /* Setup Aurora2. */ init_aurora2(); /* configure MCI mapping */ mci_remap_indirect_access_base(); /* configure IO_WIN windows */ init_io_win(MVEBU_AP0); /* configure CCU windows */ init_ccu(MVEBU_AP0); /* configure the SMMU */ setup_smmu(); /* Open AP incoming access for all masters */ ap_sec_masters_access_en(1); /* configure axi for AP */ ap807_axi_attr_init(); /* misc configuration of the SoC */ misc_soc_configurations(); } static void ap807_dram_phy_access_config(void) { uint32_t reg_val; /* Update DSS port access permission to DSS_PHY */ reg_val = mmio_read_32(DSS_SCR_REG); reg_val &= ~(DSS_PPROT_MASK << DSS_PPROT_OFFS); reg_val |= ((DSS_PPROT_PRIV_SECURE_DATA & DSS_PPROT_MASK) << DSS_PPROT_OFFS); mmio_write_32(DSS_SCR_REG, reg_val); } void ap_ble_init(void) { /* Enable DSS port */ ap807_dram_phy_access_config(); } int ap_get_count(void) { return 1; }