xlat_tables_arch.c

/*
 * Copyright (c) 2017-2018, ARM Limited and Contributors. All rights reserved.
 *
 * SPDX-License-Identifier: BSD-3-Clause
 */

#include <arch.h>
#include <arch_helpers.h>
#include <assert.h>
#include <cassert.h>
#include <platform_def.h>
#include <utils.h>
#include <utils_def.h>
#include <xlat_tables_v2.h>
#include "../xlat_tables_private.h"

#if ARM_ARCH_MAJOR == 7 && !defined(ARMV7_SUPPORTS_LARGE_PAGE_ADDRESSING)
#error ARMv7 target does not support LPAE MMU descriptors
#endif

uint64_t mmu_cfg_params[MMU_CFG_PARAM_MAX];

/*
 * Returns 1 if the provided granule size is supported, 0 otherwise.
 */
int xlat_arch_is_granule_size_supported(size_t size)
{
	/*
	 * The Trusted Firmware uses long descriptor translation table format,
	 * which supports 4 KiB pages only.
	 */
	return (size == (4U * 1024U));
}

size_t xlat_arch_get_max_supported_granule_size(void)
{
	return 4U * 1024U;
}

#if ENABLE_ASSERTIONS
unsigned long long xlat_arch_get_max_supported_pa(void)
{
	/* Physical address space size for long descriptor format. */
	return (1ULL << 40) - 1ULL;
}
#endif /* ENABLE_ASSERTIONS*/

int is_mmu_enabled_ctx(const xlat_ctx_t *ctx __unused)
{
	return (read_sctlr() & SCTLR_M_BIT) != 0;
}

uint64_t xlat_arch_regime_get_xn_desc(int xlat_regime __unused)
{
	return UPPER_ATTRS(XN);
}

void xlat_arch_tlbi_va(uintptr_t va, int xlat_regime __unused)
{
	/*
	 * Ensure the translation table write has drained into memory before
	 * invalidating the TLB entry.
	 */
	dsbishst();

	tlbimvaais(TLBI_ADDR(va));
}

void xlat_arch_tlbi_va_sync(void)
{
	/* Invalidate all entries from branch predictors. */
	bpiallis();

	/*
	 * A TLB maintenance instruction can complete at any time after
	 * it is issued, but is only guaranteed to be complete after the
	 * execution of DSB by the PE that executed the TLB maintenance
	 * instruction. After the TLB invalidate instruction is
	 * complete, no new memory accesses using the invalidated TLB
	 * entries will be observed by any observer of the system
	 * domain. See section D4.8.2 of the ARMv8 (issue k), paragraph
	 * "Ordering and completion of TLB maintenance instructions".
	 */
	dsbish();

	/*
	 * The effects of a completed TLB maintenance instruction are
	 * only guaranteed to be visible on the PE that executed the
	 * instruction after the execution of an ISB instruction by the
	 * PE that executed the TLB maintenance instruction.
	 */
	isb();
}

int xlat_arch_current_el(void)
{
	/*
	 * If EL3 is in AArch32 mode, all secure PL1 modes (Monitor, System,
	 * SVC, Abort, UND, IRQ and FIQ modes) execute at EL3.
	 *
	 * The PL1&0 translation regime in AArch32 behaves like the EL1&0 regime
	 * in AArch64 except for the XN bits, but we set and unset them at the
	 * same time, so there's no difference in practice.
	 */
	return 1;
}

/*******************************************************************************
 * Function for enabling the MMU in Secure PL1, assuming that the page tables
 * have already been created.
 ******************************************************************************/
void setup_mmu_cfg(unsigned int flags, const uint64_t *base_table,
		   unsigned long long max_pa, uintptr_t max_va,
		   __unused int xlat_regime)
{
	uint64_t mair, ttbr0;
	uint32_t ttbcr;

	assert(IS_IN_SECURE());

	/* Set attributes in the right indices of the MAIR */
	mair = MAIR0_ATTR_SET(ATTR_DEVICE, ATTR_DEVICE_INDEX);
	mair |= MAIR0_ATTR_SET(ATTR_IWBWA_OWBWA_NTR,
			ATTR_IWBWA_OWBWA_NTR_INDEX);
	mair |= MAIR0_ATTR_SET(ATTR_NON_CACHEABLE,
			ATTR_NON_CACHEABLE_INDEX);

	/*
	 * Configure the control register for stage 1 of the PL1&0 translation
	 * regime.
	 */

	/* Use the Long-descriptor translation table format. */
	ttbcr = TTBCR_EAE_BIT;

	/*
	 * Disable translation table walk for addresses that are translated
	 * using TTBR1. Therefore, only TTBR0 is used.
	 */
	ttbcr |= TTBCR_EPD1_BIT;

	/*
	 * Limit the input address ranges and memory region sizes translated
	 * using TTBR0 to the given virtual address space size, if smaller than
	 * 32 bits.
	 */
	if (max_va != UINT32_MAX) {
		uintptr_t virtual_addr_space_size = max_va + 1;
		assert(CHECK_VIRT_ADDR_SPACE_SIZE(virtual_addr_space_size));
		/*
		 * __builtin_ctzll(0) is undefined but here we are guaranteed
		 * that virtual_addr_space_size is in the range [1, UINT32_MAX].
		 */
		ttbcr |= 32 - __builtin_ctzll(virtual_addr_space_size);
	}

	/*
	 * Set the cacheability and shareability attributes for memory
	 * associated with translation table walks using TTBR0.
	 */
	if (flags & XLAT_TABLE_NC) {
		/* Inner & outer non-cacheable non-shareable. */
		ttbcr |= TTBCR_SH0_NON_SHAREABLE | TTBCR_RGN0_OUTER_NC |
			TTBCR_RGN0_INNER_NC;
	} else {
		/* Inner & outer WBWA & shareable. */
		ttbcr |= TTBCR_SH0_INNER_SHAREABLE | TTBCR_RGN0_OUTER_WBA |
			TTBCR_RGN0_INNER_WBA;
	}

	/* Set TTBR0 bits as well */
	ttbr0 = (uint64_t)(uintptr_t) base_table;

#if ARM_ARCH_AT_LEAST(8, 2)
	/*
	 * Enable CnP bit so as to share page tables with all PEs. This
	 * is mandatory for ARMv8.2 implementations.
	 */
	ttbr0 |= TTBR_CNP_BIT;
#endif

	/* Now populate MMU configuration */
	mmu_cfg_params[MMU_CFG_MAIR] = mair;
	mmu_cfg_params[MMU_CFG_TCR] = (uint64_t) ttbcr;
	mmu_cfg_params[MMU_CFG_TTBR0] = ttbr0;
}