• Sandrine Bailleux's avatar
    Move to the new ARM SCP Messaging Interfaces · e234ba03
    Sandrine Bailleux authored
    The communication protocol used between the AP cores and the SCP
    in CSS-based platforms like Juno has undergone a number of changes.
    This patch makes the required modifications to the SCP Boot Protocol,
    SCPI Protocol and MHU driver code in shared CSS platform code so that
    the AP cores are still able to communicate with the SCP.
    
    This patch focuses on the mandatory changes to make it work. The
    design of this code needs to be improved but this will come in
    a subsequent patch.
    
    The main changes are:
    
     - MHU communication protocol
    
       - The command ID and payload size are no longer written into the
         MHU registers directly. Instead, they are stored in the payload
         area. The MHU registers are now used only as a doorbell to kick
         off messages. Same goes for any command result, the AP has to
         pick it up from the payload area.
    
     - SCP Boot Protocol
    
       - The BL3-0 image is now expected to embed a checksum. This
         checksum must be passed to the SCP, which uses it to check the
         integrity of the image it received.
    
       - The BL3-0 image used to be transferred a block (4KB)
         at a time. The SCP now supports receiving up to 128KB at a
         time, which is more than the size of the BL3-0 image.
         Therefore, the image is now sent in one go.
    
       - The command IDs have changed.
    
     - SCPI Protocol
    
       - The size of the SCPI payload has been reduced down from 512
         bytes to 256 bytes. This changes the base address of the
         AP-to-SCP payload area.
    
       - For commands that have a response, the response is the same SCPI
         header that was sent, except for the size and the status, which
         both must be updated appropriately. Success/Failure of a command
         is determined by looking at the updated status code.
    
       - Some command IDs have changed.
    
    NOTE: THIS PATCH BREAKS COMPATIBILITY WITH FORMER VERSIONS OF THE SCP
    FIRMWARE AND THUS REQUIRES AN UPDATE OF THIS BINARY. THE LATEST SCP
    BINARY CAN BE OBTAINED FROM THE ARM CONNECTED COMMUNITY WEBSITE.
    
    Change-Id: Ia5f6b95fe32401ee04a3805035748e8ef6718da7
    e234ba03
css_mhu.h 1.84 KB