zynqmp: pm_service: Ignore enable/disable of PLL type clocks

PLL type clock is enabled by FSBL on boot-up. PMUFW enable/disable
them based on their user count. So, it should not be handled from ATF.

Put PLL type clock into bypass and reset mode only while changing
PLL rate (FBDIV).
Signed-off-by: Tejas Patel <tejas.patel@xilinx.com>
Acked-by: Will Wong <WILLW@xilinx.com>
Signed-off-by: Siva Durga Prasad Paladugu <siva.durga.paladugu@xilinx.com>

plat/xilinx/zynqmp/pm_service/pm_api_clock.c

@@ -2627,10 +2627,11 @@ enum pm_ret_status pm_api_clock_enable(unsigned int clock_id)
 	if (pm_clock_type(clock_id) != CLK_TYPE_OUTPUT)
 		return PM_RET_ERROR_NOTSUPPORTED;
 
-	if (ISPLL(clock_id))
-		ret = pm_api_pll_bypass_and_reset(clock_id,
-						  CLK_PLL_RESET_PULSE);
-	else
+	/*
+	 * PLL type clock should not enable explicitly.
+	 * It is done by FSBL on boot-up and by PMUFW whenever required.
+	 */
+	if (!ISPLL(clock_id))
 		ret = pm_api_clk_enable_disable(clock_id, 1);
 
 	return ret;
@@ -2656,10 +2657,11 @@ enum pm_ret_status pm_api_clock_disable(unsigned int clock_id)
 	if (pm_clock_type(clock_id) != CLK_TYPE_OUTPUT)
 		return PM_RET_ERROR_NOTSUPPORTED;
 
-	if (ISPLL(clock_id))
-		ret = pm_api_pll_bypass_and_reset(clock_id,
-						  CLK_PLL_RESET_ASSERT);
-	else
+	/*
+	 * PLL type clock should not be disabled explicitly.
+	 * It is done by PMUFW if required.
+	 */
+	if (!ISPLL(clock_id))
 		ret = pm_api_clk_enable_disable(clock_id, 0);
 
 	return ret;
@@ -2807,8 +2809,13 @@ static enum pm_ret_status pm_api_pll_set_divider(unsigned int clock_id,
 					  unsigned int divider)
 {
 	unsigned int reg = clocks[clock_id].control_reg;
+	enum pm_ret_status ret;
 
-	return pm_mmio_write(reg, PLL_FBDIV_MASK, divider << PLL_FBDIV_SHIFT);
+	pm_api_pll_bypass_and_reset(clock_id, CLK_PLL_RESET_ASSERT);
+	ret = pm_mmio_write(reg, PLL_FBDIV_MASK, divider << PLL_FBDIV_SHIFT);
+	pm_api_pll_bypass_and_reset(clock_id, CLK_PLL_RESET_RELEASE);
+
+	return ret;
 }
 
 /**