GitLab

This commit improves the SDHost driver for RPi3 as following:
 * Unblock MMC_CMD(17). Using MMC_CMD(17) is more efficient on
   block reading.
 * In some low probability that SEND_OP_COND might results CRC7
   error. We can consider that the command runs correctly. We don't
   need to retry this command so removing the code for retry.
 * Using MMC_BUS_WIDTH_1 as MMC default value to improve the stability.
 * Increase the clock to 50Mhz in data mode to speed up the io.
 * Change the pull resistors configuration to gain more stability.
Signed-off-by: Ying-Chun Liu (PaulLiu) <paulliu@debian.org>

Update documentation for STM32MP1 and add Cortex-M4 support

Apply official names to new Arm Neoverse cores

Introduce Versatile Express FVP platform to arm-trusted-firmware.

rcar_gen3: plat: Prevent PCIe hang during L1X config access

STM32MP1 chip embeds a dual Cortex-A7 and a Cortex-M4.
The support for Cortex-M4 clocks is added when configuring the clock tree.
Some minimal security features to allow communications between A7 and M4
are also added.

Change-Id: I60417e244a476f60a2758f4969700b2684056665
Signed-off-by: Yann Gautier <yann.gautier@st.com>

A link to st.com page describing STM32MP1 is added.
Add the information about Cortex-M4 embedded in STM32MP1.
Correct typo for u-boot command.

Change-Id: Ie900f6ee59461c5e7ad8a8b06854abaf41fca3ce
Signed-off-by: Yann Gautier <yann.gautier@st.com>

In case the PCIe controller receives a L1_Enter_PM DLLP, it will
disable the internal PLLs. The system software cannot predict it
and can attempt to perform device config space access across the
PCIe link while the controller is in this transitional state. If
such condition happens, the PCIe controller register access will
trigger ARM64 SError exception.

This patch adds checks for which PCIe controller is enabled,
checks whether the PCIe controller is in such a transitional
state and if so, first completes the transition and then restarts
the instruction which caused the SError.
Signed-off-by: Marek Vasut <marek.vasut+renesas@gmail.com>

docs: Document romlib design

docs: Update documentation about ARMv8.2-TTCNP

This documentation contains information about the boot sequence,
code location and build procedure for fvp_ve platform.

Change-Id: I339903f663cc625cfabc75ed8e4accb8b2c3917c
Signed-off-by: Usama Arif <usama.arif@arm.com>

Cortex A5 doesnt support VFP, Large Page addressing and generic timer
which are addressed in this patch. The device tree for Cortex a5
is also included.

Change-Id: I0722345721b145dfcc80bebd36a1afbdc44bb678
Signed-off-by: Usama Arif <usama.arif@arm.com>

Cortex a5 doesnt support hardware division such as sdiv and udiv commands.
This commit adds a software division function in assembly as well as include
appropriate files for software divison.

The software division algorithm is a modified version obtained from:
http://www.keil.com/support/man/docs/armasm/armasm_dom1359731155623.htm



Change-Id: Ib405a330da5f1cea1e68e07e7b520edeef9e2652
Signed-off-by: Usama Arif <usama.arif@arm.com>

Support 32bit descriptor MMU table. This is required by ARMv7
architectures that do not support the Large Page Address Extensions.

nonlpae_tables.c source file is dumped from the OP-TEE project:
core_mmu_armv7.c and related header files.

Change-Id: If912d66c374290c49c5a1211ce4c5c27b2d7dc60
Signed-off-by: Etienne Carriere <etienne.carriere@linaro.org>
Signed-off-by: Usama Arif <usama.arif@arm.com>

This patch adds support for Versatile express FVP (Fast models).
Versatile express is a family of platforms that are based on ARM v7.
Currently this port has only been tested on Cortex A7, although it
should work with other ARM V7 cores that support LPAE, generic timers,
VFP and hardware divide. Future patches will support other
cores like Cortex A5 that dont support features like LPAE
and hardware divide. This platform is tested on and only expected to
work on single core models.

Change-Id: I10893af65b8bb64da7b3bd851cab8231718e61dd
Signed-off-by: Usama Arif <usama.arif@arm.com>

Change-Id: I2b75be16f452a8ab7c2445ccd519fb057a135812
Co-authored-by: John Tsichritzis <john.tsichritzis@arm.com>
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Commit 2559b2c8

 ("xlat v2: Dynamically detect need for CnP bit")
modified the code to convert the compile-time check for ARMv8.2-TTCNP to
a runtime check, but forgot to update the documentation associated to it.

Change-Id: I6d33a4de389d976dbdcce65d8fdf138959530669
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

Change-Id: I1adcf195c0ba739002f3a59e805c782dd292ccba
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Change-Id: I33bdb9df0462b056adbd00922b2e73eb720560b3
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Change-Id: Ideb49011da35f39ff1959be6f5015fa212ca2b6b
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Change-Id: I0bb5aca9bb272332340b5baefc473a01f8a27896
Signed-off-by: John Tsichritzis <john.tsichritzis@arm.com>

Update macro to check need for CVE-2017-5715 mitigation

The variable is renamed to PLAT_ARM_RUN_UART as
the UART is used outside BL31 as well.

Change-Id: I00e3639dfb2001758b7d24548c11236c6335f64a
Signed-off-by: Usama Arif <usama.arif@arm.com>

fvp: trusty: Move dynamic xlat enable to platform

SPM: Remove unnecessary register save

Series of new patches for STM32MP1

docs: Update note about plat/arm in Porting Guide

Since commit 01fc1c24

 ("BL31: Use helper function to save registers
in SMC handler") all the general-purpose registers are saved when
entering EL3. It isn't needed to save them here.

Change-Id: Ic540a5441b89b70888da587ab8fc3b2508cef8cc
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

Armv8.5 introduces the field CSV2 to register ID_AA64PFR0_EL1. It can
have the following 3 values:

- 0: Branch targets trained in one hardware described context may affect
     speculative execution in a different hardware described context. In
     some CPUs it may be needed to apply mitigations.

- 1: Branch targets trained in one hardware described context can only
     affect speculative execution in a different hardware described
     context in a hard-to-determine way. No mitigation required.

- 2: Same as 1, but the device is also aware of SCXTNUM_ELx register
     contexts. The TF doesn't use the registers, so there is no
     difference with 1.

The field CSV2 was originally introduced in the TRM of the Cortex-A76
before the release of the Armv8.5 architecture. That TRM only mentions
the meaning of values 0 and 1. Because of this, the code only checks if
the field has value 1 to know whether to enable or disable the
mitigations.

This patch makes it aware of value 2 as well. Both values 1 and 2
disable the mitigation, and 0 enables it.

Change-Id: I5af33de25a0197c98173f52c6c8c77b51a51429f
Signed-off-by: Antonio Nino Diaz <antonio.ninodiaz@arm.com>

Add the device tree files to support the 2 discovery boards: DK1 & DK2.

Change-Id: I90b4797dc69bd0aab1b643a72c932ead48a03c1f
Signed-off-by: Yann Gautier <yann.gautier@st.com>

Remove useless private structure in function prototypes.
Add a reference counter on clocks.
Prepare for future secured/shared/non-secured clocks.

Change-Id: I3dbed81721da5ceff5e10b2c4155b1e340c036ee
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Lionel Debieve <lionel.debieve@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

This change makes the platform to panic in case of peripheral reset
resource malfunction.

Change-Id: I17eb9cb045b78a4e5142a8c33b744e84992d732a
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

PWR, RCC, DDRPHYC & DDRCTRL addresses can be retrieved from device tree.
Platform asserts the value read from the DT are the SoC addresses.

Change-Id: I43f0890b51918a30c87ac067d3780ab27a0f59de
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

Create a new file stm32mp_clkfunc.c to put functions that could be common
between several platforms.

Change-Id: Ica915c796b162b2345056b33328acc05035a242c
Signed-off-by: Yann Gautier <yann.gautier@st.com>

Regulator configuration at boot takes more information from DT.
I2C configuration from DT is done in I2C driver.
I2C driver manages more transfer modes.
The min voltage of buck1 should also be increased to 1.2V,
else the platform does not boot.

Heavily modifies stm32_i2c.c since many functions move inside the source
file to remove redundant declarations.

Change-Id: I0bee5d776cf3ff15e687427cd6abc06ab237d025
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Lionel Debieve <lionel.debieve@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

Remove the previously use function: get_timer, and use new functions
timeout_init_us and timeout_elapsed.

Change-Id: I4e95b123648bff7ca91e40462a2a3ae24cfe1697
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>
Signed-off-by: Nicolas LE BAYON <nicolas.le.bayon@st.com>

timeout_init_us(some_timeout_us); returns a reference to detect
timeout for the provided microsecond delay value from current time.

timeout_elapsed(reference) return true/false whether the reference
timeout is elapsed.

This change is inspired by the OP-TEE OS timeout resources [1].

 [1] https://github.com/OP-TEE/optee_os/blob/3.4.0/core/arch/arm/include/kernel/delay.h#L45



Change-Id: Id81ff48aa49693f555dc621064878417101d5587
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@linaro.org>

Include all RCC, clocks and reset headers from stm32mp1_def.h
which if exported to the firmware through platform_def.h.
The same dependency removal is done in common code as well.
Some useless includes are also removed in stm32_sdmmc2 driver.

Change-Id: I731ea5775c3fdb7f7b0c388b93923ed5e84b8d3f
Signed-off-by: Yann Gautier <yann.gautier@st.com>

Mainly remove suffix 1 from prefix stm32mp1 in several macros and functions
that can be used in drivers shared by different platforms.

Change-Id: I2295c44f5b1edac7e80a93c0e8dfd671b36e88e7
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>

Some parts of code could be shared with platform derivatives,
or new platforms.
A new folder plat/st/common is created to put common parts.

stm32mp_common.h is a common API aggregate.

Remove some casts where applicable.
Fix some types where applicable.
Remove also some platform includes that are already in stm32mp1_def.h.

Change-Id: I46d763c8d9e15732d1ee7383207fd58206d7f583
Signed-off-by: Yann Gautier <yann.gautier@st.com>
Signed-off-by: Etienne Carriere <etienne.carriere@st.com>