GitLab

A TZC400 controller is placed inline on DRAM channels and regulates
the secure and non-secure accesses to both secure and non-secure
regions of the DRAM memory. Configure each of the TZC controllers
across the Chips.

For use by secure software, configure the first chip's trustzone
controller to protect the upper 16MB of the memory of the first DRAM
block for secure accesses only. The other regions are configured for
non-secure read write access. For all the remote chips, all the DRAM
regions are allowed for non-secure read and write access.
Signed-off-by: Aditya Angadi <aditya.angadi@arm.com>
Change-Id: I809f27eccadfc23ea0ef64e2fd87f95eb8f195c1

Reference Design platform RD-Daniel-ConfigXLR has been renamed to
RD-V1-MC. Correspondingly, remove all uses of 'rddanielxlr' and replace
it with 'rdv1mc' where appropriate.
Signed-off-by: Aditya Angadi <aditya.angadi@arm.com>
Change-Id: I5d91c69738397b19ced43949b4080c74678e604c

RD-Daniel Config-XLR platform has four identical chips connected via a
high speed coherent CCIX link. Each chip has four Neoverse cores
connected via coherent CMN interconnect.

Change-Id: I37d1b91f2b6ba08f61c64d0288bc16a429836c08
Signed-off-by: Aditya Angadi <aditya.angadi@arm.com>

This adds the minimal functions and definitions to create a basic
BL31 port for an initial FPGA image, in order for the port to be
uploaded to one the FPGA boards operated by an internal group within
Arm, such that BL31 runs as a payload for an image.

Future changes will enable the port for a wide range of system
configurations running on the FPGA boards to ensure compatibility with
multiple FPGA images.

It is expected that this will replace the FPGA fork of the Linux kernel
bootwrapper by performing similar secure-world initialization and setup
through the use of drivers and other well-established methods, before
passing control to the kernel, which will act as the BL33 payload and
run in EL2NS.

This change introduces a basic, loadable port with the console
initialized by setting the baud rate and base address of the UART as
configured by the Zeus image.

It is a BL31-only port, and RESET_TO_BL31 is enabled to reflect this.
Signed-off-by: Oliver Swede <oli.swede@arm.com>
Change-Id: I1817ad81be00afddcdbbda1ab70eb697203178e2